ZyXEL Communications XGS-4526 - Manual (Page 89)

Chapter 8 Basic Setting
XGS-4526 User’s Guide
89
8.7 Port Setup
Use this screen to configure Switch port settings.Click Basic Setting > Port
Setup in the navigation panel to display the configuration screen.
Figure 42 Basic Setting > Port Setup
The following table describes the labels in this screen.
IP Subnet
Mask This field displays the subnet mask of the Switch in the IP domain.
VID This field displays the VLAN identification number of the IP domain on the
Switch.
Delete Click Delete to remove the selected entry from the summary table.
Note: Deleting all IP subnets locks you out of the Switch.
Cancel Click Cancel to clear the Delete check boxes.
Table 14 Basic Setting > IP Setup (continued)
LABEL DESCRIPTION
Table 15 Basic Setting > Port Setup
LABEL DESCRIPTION
Port This is the port index number.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports.
Use this row first to set the common settings and then make adjustments
on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Active Select this check box to enable a port. The factory default for all ports is
enabled. A port must be enabled for data transmission to occur.