ZyXEL Communications XGS-4526 - Manual (Page 394)

Chapter 47 Configure Clone
XGS-4526 User’s Guide
394
The following table describes the labels in this screen.
Table 147 Management > Configure Clone
LABEL DESCRIPTION
Source/
Destination
Port
Enter the source port under the Source label. This port’s attributes are
copied.
Enter the destination port or ports under the Destination label. These are
the ports which are going to have the same attributes as the source port.
You can enter individual ports separated by a comma or a range of ports by
using a dash.
Example:
• 2, 4, 6 indicates that ports 2, 4 and 6 are the destination ports.
• 2-6 indicates that ports 2 through 6 are the destination ports.
Basic
Setting Select which port settings (configured in the Basic Setting menus) should
be copied to the destination port(s).
Advanced
Application Select which port settings (configured in the Advanced Application
menus) should be copied to the destination ports.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.