Z Microsystems SL - Manual (Page 7)

Doc# 27-0032UM Rev A Issued 07/05
7
HARDWARE INSTALLATION
INSTALLATION
Remove the outer rack mounting slide
channels from the Console.
On the rear unscrew the left and right
rear rack mounting brackets to free up
the outer rack mounting slide channels
from the Console.
Press the spring loaded Z Locks towards
the middle to release the outer rack
mount slide channels and at the same
time slide the rack mounting block back.
Slide the channels back until they stop
about half way back. This is a safety stop
to prevent the Console from sliding out
too far while mounted to the rack.
Simultaneously press in the first set of
safety catches on each slide rail and
slide the channel until the second safety
catches stop the sliding action.
Simultaneously press in the second set
of safety catches on each slide rail and
slide the channel all the way off the back
of the Console.