Z Microsystems SL - Manual (Page 9)

Doc# 27-0032UM Rev A Issued 07/05
9
INSTALLATION
To mount the channels on the front of the
RETMA rails (in most cases), use two 10-
32 Phillips screws...
on each side to secure the Z-Lock mounts.
Be sure to press the slide rail flat against
the RETMA rail as you tighten the screws.
On the rear of the cabinet frame, also use
two Phillips screws on each rail to secure.
On the slide rails, using a screwdriver and
wrench, tighten the slide extension rail
screw. Repeat on each side.