ZyXEL Communications 792H - Manual (Page 259)

Prestige 792H G.SHDSL Router
Dial Backup 21-9
Table 21-5 Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
Private This parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept private
and not included in RIP broadcasts. If No, the route to this remote node
will be propagated to other hosts through RIP broadcasts. No
(default)
RIP
Direction Press [SPACE BAR] and then [ENTER] to select the RIP direction from
Both/ None/In Only/Out Only and None. Both
(default)
Version Press [SPACE BAR] and then [ENTER] to select the RIP version from
RIP-1/RIP-2B/RIP-2M.
RIP-1
Multicast IGMP (Internet Group Multicast Protocol) is a session-layer protocol
used to establish membership in a Multicast group. The Prestige
supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).
Press the [SPACE BAR] to enable IP Multicasting or select None to
disable it. See the LAN Setup chapter for more information on this
feature. None
(default)
Once you have completed filling in Menu 11.3 Remote Node Network Layer Options, press [ENTER]
at the message “Press ENTER to Confirm...” to save your configuration and return to menu 11, or press
[ESC] at any time to cancel.
21.2.3 Editing Filter Sets
Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set the value
to Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the Prestige to prevent certain packets from triggering calls. You can specify up to four filter sets
separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this
field. Please refer to the Filters chapter for more information on defining the filters.