ZyXEL Communications 792H - Manual (Page 263)

Prestige 792H G.SHDSL Router
LAN 22-3
Figure 22-4 IP Alias Setup
Follow the instructions in the following table to configure IP Alias parameters.
Table 22-1 IP Alias Setup
FIELD DESCRIPTION EXAMPLE
IP Alias Choose Yes to configure the LAN network for the Prestige. Yes
IP Address Enter the IP address of your Prestige in dotted decimal notation 192.168.2.1
IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the Prestige
255.255.255.0
RIP Direction Press [ SPACE BAR ] to select the RIP direction. Choices are None,
Both, In Only or Out Only.
None
Version Press [ SPACE BAR] to select the RIP version. Choices are RIP-1,
RIP-2B or RIP-2M.
RIP-1
Incoming
Protocol Filters Enter the filter set(s) you wish to apply to the incoming traffic
between this node and the Prestige.
Outgoing
Protocol Filters Enter the filter set(s) you wish to apply to the outgoing traffic between
this node and the Prestige.
When you have completed this menu, press [ ENTER ] at the prompt “Press ENTER to Confirm…” to
save your configuration, or press [ ESC ] at any time to cancel.
22.1.3 Route IP Setup
You must enable IP routing for Internet access. You can enable IP routing in Menu 1 — General Setup.
To edit menu 1, type in 1 in the main menu and press [ENTER]. Set the Route IP field to Yes by pressing
[SPACE BAR].