ZyXEL Communications 792H - Manual (Page 279)

Prestige 791R G.SHDSL Router
Remote Node TCP/IP Configuration 24-9
Figure 24-6 Remote Node Filter (RFC1483 or ENET ENCAP Encapsulation)
24.5 Editing ATM Layer Options
Follow these steps to edit Menu 11.6 – Remote Node ATM Layer Options.
Step 1. In Menu 11.1, move the cursor to the Edit ATM Options then press [SPACE BAR] to toggle
and set the value to Yes.
Step 2. Press [ENTER] to open Menu 11.6 – Remote Node ATM Layer Options.
There are two versions of Menu 11.6 for the Prestige, depending on whether you chose VC-based or LLC-
based multiplexing and PPP (either PPPoA or PPPoE) encapsulation in menu 11.1.
24.5.1 VC-based Multiplexing (non-PPP Encapsulation)
For VC-based multiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, e.g., VC1
will carry IP, VC2 will carry IPX, etc. Separate VPI and VCI numbers must be specified for each protocol.
Figure 24-7 Menu 11.6 for VC-based Multiplexing (non-PPP Encapsulation)
Menu 11.6 - Remote Node ATM Layer Options
VPI/VCI (VC-Multiplexing)
VC Options for IP: VC Options for Bridge:
VPI #= 0 VPI #= N/A
VCI #= 38 VCI #= N/A
ATM QoS Type= UBR ATM QoS Type= N/A
Peak Cell Rate (PCR)= 0 Peak Cell Rate (PCR)= N/A
Sustain Cell Rate (SCR)= 0 Sustain Cell Rate (SCR)= N/A
Maximum Burst Size (MBS)= 0 Maximum Burst Size (MBS)= N/A
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.
Separate VPI and
VCI numbers must
be specified.