ZyXEL Communications 792H - Manual (Page 278)

Prestige 791R G.SHDSL Router
24-8 Remote Node TCP/IP Configuration
Figure 24-4 Sample IP Addresses for a TCP/IP LAN-to-LAN Connection
24.4 Remote Node Filter
Move the cursor to the Edit Filter Sets field in menu 11.1, then press [SPACE BAR] to select Yes. Press
[ENTER] to display Menu 11.5 – Remote Node Filter.
Use Menu 11.5 – Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between this remote node and the Prestige and also to prevent certain packets from triggering calls.
You can specify up to 4 filter sets separated by comma, for example, 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field. The Prestige has prepackaged filter sets; refer to the chapter on
Filter Configuration for details. Include these in the call filter sets if you want to prevent NetBIOS packets
from triggering calls to a remote node.
Figure 24-5 Remote Node Filter (PPPoA or PPPoE Encapsulation)
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 12, 11
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL:
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 12, 11
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL: