Xantrex Technology XTR 850 Watt - Manual (Page 232)

A-24 975-0200-01-01 S
C
PI
C
o
mm
an
d
R
e
fe
re
n
ce
Select Current
Analog
Programming
Input Voltage
Input Level/
Range [:]SYSTem[<channel>]:COMMunicate
:APRogram:LEVel:CURRent[:ISOLated]
Select level for Current
APG. Level can be between
2 -10 volts. ?|<Level(2–
10)>|MAXimum|MI
Nimum Yes
Select the
address to
communicate
with. [:]SYSTem[<channel>]:COMMunicate
[:MCHannel]:ADDRess
Select the current device to
receive the commands. The
parameter for this
command is the address set
on the front panel under the
remote Yes
Select
Address [:]SYSTem:COMMunicate[:SELF]:ADDRess Select the power supply
unit to communicate with. ?|<Address (1–30) Yes
Setup the
Voltage
control source
for Isolated
APG. [:]SYSTem[<channel>]:REMote:SOURce
[:VOLTAGage]:ISOLated
Alter or query the state of
the remote programming
Isolated Voltage APG
source. ?|LOCal|AVOLtage
|ARESistive
Yes
Setup the
Voltage
control source
for Non-
Isolated APG. [:]SYSTem[<channel>]:REMote:SOURce
[:VOLTAGage]:[NISOlated]
Query remote control
source for voltage. ?|LOCal|AVOLtage
|ARESistive
Yes
Setup the
Current
control source
for Isolated
APG. [:]SYSTem[<channel>]:REMote:SOURce
:CURRent:ISOLated
Query remote control
source for isolated voltage. ?|LOCal|AVOLtage
|ARESistive
Yes
Table A-9 System Commands (Continued)