Edimax Technology 3G-6200Wg - Manual (Page 56)

55
IP address 192.168.2.1
This is the router’s LAN port IP address
(Your LAN clients default gateway IP
address)
IP Subnet Mask 255.255.255.0
Specify a Subnet Mask for your LAN
segment
802.1d Spanning
Tree
Disabled
If 802.1d Spanning Tree function is
enabled, this router will use the spanning
tree protocol to prevent from network loop
happened in the LAN ports.
DHCP Server Enabled
You can enable or disable the DHCP
server. By enabling the DHCP server the
router will automatically give your LAN
clients an IP address. If the DHCP is not
enabled then you’ll have to manually set
your LAN client’s IP addresses; make sure
the LAN Client is in the same subnet as
this broadband router if you want the router
to be your LAN client’s default gateway
Lease Time
When enabled, DHCP service will
temporarily give your LAN clients an IP
address. In the Lease Time setting you can
specify the time period that the DHCP
lends an IP address to your LAN clients.
The DHCP will change your LAN client’s IP
address when this time period is reached
IP Address Pool
You can select a particular IP address
range for your DHCP server to issue IP
addresses to your LAN Clients.
Note: By default the IP range is from:
192.168.2.100 to 192.168.2.200. If you
want your PC to have a static/fixed IP
address then you’ll have to choose an IP
address outside this IP address Pool.
Domain Name
You can specify a Domain Name for your
LAN.
Click <Apply> at the bottom of the screen to save the configurations. You can
now configure other advance sections or start using the router.