Edimax Technology 3G-6200Wg - Manual (Page 88)

87
Parameters Description
Enable Static
Routing
Static routing function is disabled by default. You have to
enable the static routing function, to make your routing rules
take effect.
Destination
LAN IP
The network address of destination LAN.
Subnet Mask The subnet mask of destination LAN.
Default
Gateway
The next stop gateway of the path toward the destination
LAN. This is the IP of the neighbor router that this router
should communicate with on the path to the destination LAN.
Hop Count
The number of hops (routers) to pass through to reach the
destination LAN.
Interface The interface that go to the next hop (router).
Add a Rule
Fill in the "Destination LAN IP", "Subnet Mask”, “Default
Gateway”, "Hop Count" and "Interface" of the rule to be
added and click "Add". Then this static routing rule will be
added to the "Static Routing Table" listed below. If you found
any typo before adding it and want to correct it, just click
"Reset" and the fields will be cleared.
Remove a
Rule
If you want to remove some routing rules from the "Static
Routing Table", select the rules you want to remove in the
table and click "Delete Selected". If you want remove all
rules from the table, just click "Delete All" button. Click
"Reset" will clear your current selections.
Click <Apply> at the bottom of the screen to save the configurations. You can
now configure other advance sections or start using the router.