Acroprint HandPunch 4000 - Manual (Page 50)

Enter a Command Menu
48
Enter Password
4. Enter the password for the menu you wish to enter. The default passwords
are as follows:
Press 1 for the Service Menu.
Press 2 for the Setup Menu.
Press 3 for the Management Menu.
Press 4 for the Enrollment Menu.
Press 5 for the Security Menu.
5. Press ENTER
6. If you are authorized to use this command, the first command option in the
selected menu appears.
7. If you are not authorized to enter this command, the display appears as
follows:
ENTER ID
*:
To access these menus you must be the first person enrolled in a new system
installation or you must have been enrolled as a supervisor. If you are blocked
from the supervisory menus, verify your access rights with management
personnel. If enrollment information has been incorrectly changed and you
must have supervisory access to all menus, make these changes through
software.
It is possible to physically reset the HandPunch’s memory, however resetting
memory sets all unit parameters back to the factory default values. Resetting
memory allows access to all menus by the first person enrolled (as if it is
a new system installation), but this means that
all employee information
programmed into the HandPunch is lost and must be re-entered
manually. Be sure you need to reset memory before performing this function.
To reset memory, refer to the Erasing HandPunch Memory section on page 43.
NOTE
NOTE