Acroprint HandPunch 4000 - Manual (Page 74)

Appendix B - Board Configuration Differences
72
Appendix B
Noted Board Configuration Differences
Because of Schlage Biometrics’ camera retrofit of the HandPunch some
changes have been made to the main PCB and they are listed as follows:
• Dipswitches have been removed
-comm lines are terminated.
-RS-485 is set by wiring jumpers.
-memory is reset with a push-button reset and user interface with
keypad and LCD.
• The labeling of the terminal strips have changed. See “Figure 11-1” on
page 73.
• The configuration of the terminal strips have changed. See “Figure 11-2”
on page 74.
• Power has moved to the right side of the PCB.
• The RSS-232 RJ-45 receptacle has been replaced with a 4 pin Molex
connector on the left side of the PCB.
• A 2 pin Molex connector (J5) has been added to the board, next to the
reset button, to supply power for the LEDs. This connector should never be
unplugged. unless a modem or Ethernet is added to the PCB.
• The upgrading of the memory is now handled through software codes at
the HandPunch. Contact Order Entry for memory upgrades.