Acroprint HandPunch 4000 - Manual (Page 95)

HandPunch 3000/4000 Manual
93
Perform the following steps to erase the configuration data but retain the
user database.
1. With system power OFF, set switch 4 ON.
2. Turn system power ON and wait for HandPunch boot information to
appear on the display.
3. Turn switch 4 OFF.
Perform the following steps to erase both the configuration data and the user
database.
1. With system power OFF, set both switches 4 and 5 ON.
2. Turn system power ON and wait 5 seconds.
3. Turn both switches 4 and 5 OFF.
Before putting the HandPunch into service ensure DIP switches 4 and 5 are
both OFF. If switches 4 and 5 are not off, the next time the HandPunch’s
power is cycled the HandPunch’s memory will be erased.
Erasing the
HandPunch
Setup
Erasing the
HandPunch
Setup and
User Database
NOTE