Acroprint HandPunch 4000 - Manual (Page 88)

Appendix C - Old Board Configuration
86
26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7
These components are not supplied by Recognition Systems, Inc.
The Aux 1 and Aux 2 input contact states are programmable within
the HandPunch unit.
TOP OF THE
HAND READER
HINGE
WALL TO WHICH
THE HANDPUNCH
IS ATTACHED AUX OUTPU
T
2
AUX OUTPU
T
1
AUX INPU
T
2
AUX INPU
T
1
N.C. DOOR SWITC
H
REQUES
T
TO
EXI
T
SWITCH LEGEND
N.C. DOOR SWITCH
N.O. MOMENTARY
GROUND
CLOCK
CLOCK
GROUND
DATA
DATA
+5 VDC POWER
(SEE NOTE BELOW)
NOTE: For +12 VDC magnetic stripe readers, connect the magnetic stripe reader
power supply to J6 on the Hand Punch.
Access Control
Panel
ABA-Track II
Magnetic Stripe Card Reader
HandPunch
Power
Connection
RJ-11/RS-422
4-wire
Network
Optional RJ-45
Ethernet or
RJ-11 Modem
RJ-45/RS-232
Printer Output
J6
+12 VDC for
12 Volt External
Card Readers
1
2
1
2 2
1
Figure 13-10: External Card Reader Wiring DIagram