Acroprint HandPunch 4000 - Manual (Page 56)

Programming the HandPunch
54
Service Menu
The Service menu commands provide information that help you determine if
the HandPunch is performing within normal operating parameters and identify
the status of the unit’s inputs and outputs. The following section provides a
brief summary of the Service Menu commands.
There are no user serviceable parts inside the HandPunch.
Enter the appropriate password to enter the Service command menu. Once
you have entered the command menu, there are three options available for
navigating the command menu system.
• Press # to enter the command shown on the display.
• Press * to step to the next command in the menu.
• Press CLEAR to exit the command menu (pressing any numeric key also
exits the command menu). If you are in a command’s sub-menu, press
CLEAR multiple times to completely exit the command menu.
There are two commands available from the Service command menu.
• Calibrate
• Status Display
Refer to Table 7 and identify the command you need to perform. Step through
all previous commands until you reach the desired command.
Table 7: Service Command Menu
Service Menu
Password = 1
Calibrate
Recal (Y/N)
Status Display
On/Off (Y/N)
NOTE
Navigating
the Service
Command
Menu
Service
Commands