Setup menu – Acroprint HandPunch 4000 User Manual
Page 58
Programming the HandPunch
56
Setup Menu
The Setup menu commands allow you to set the basic operating parameters
for the HandPunch unit. The following section provides a brief summary of all
the parameters that may be set on a HandPunch unit.
Once in the Command Menu, you can step through and set the parameters
for each command sequentially. You do not have to exit command mode after
setting any individual command.
Enter the appropriate password to enter the Setup command menu. Once
you have entered the command menu, there are three options available for
navigating the command menu system.
•
Press
#
to enter the command shown on the display.
•
Press
*
to step to the next command in the menu.
•
Press
CLEAR to exit the command menu (pressing any numeric key
also exits the command menu). If you are in a command’s sub-menu, press
CLEAR multiple times to completely exit the command menu.
There are six commands available from the Setup command menu:
•
Set Language
•
Set Date Format
•
Set Date and Time
•
Set Address
•
Set ID Length
•
Set Serial
•
Set Output Mode
Refer to “Table 9” on page 57 and identify the command you need to perform.
Step through all previous commands until you reach the desired command.
Navigating
the Setup
Command
Menu
Setup
Commands
NOTE