Selecting a direct-to waypoint – Garmin G1000 Piper PA32 User Manual
Page 167
GPS NAVIGATION
190-00692-00 Rev. B
5-33
Garmin G1000 Pilot’s Guide for Piper PA32
SELECTING A DIRECT-TO WAYPOINT
Selecting and activating a direct-to destination by entering an identifier:
1)
Press the
Direct-to
(
)
Key.
2)
Enter the destination waypoint identifier (Figure 5-26).
Figure 5-26 Entering an Identifier
3)
Press the
ENT
Key to confirm the identifier. The ‘Activate?’ field is highlighted (Figure 5-27).
Figure 5-27 Activate Field
Activate Field
4)
If no altitude constraint or course is desired, press the
ENT
Key to activate. To enter an altitude constraint,
proceed to step 5.
5)
Turn the large
FMS
Knob to place the cursor over the ‘VNV’ altitude field (Figure 5-28).
Figure 5-28 Entering a Direct-to Altitude Constraint
VNV Altitude
Constraint Field
6)
Enter the desired altitude.
7)
Press the
ENT
Key. The option to select MSL or AGL is now displayed.