Garmin G1000 Piper PA32 - Manual (Page 63)

190-00692-00 Rev. B Garmin G1000 Pilot’s Guide for Piper PA32 2-13
FLIGHT INSTRUMENTS
Under the following conditions, the bearing pointer is removed from the HSI and “NO DATA” is displayed
in the information window:
• The NAV radio is not receiving the tuned VOR station
• GPS is the bearing source and an active waypoint is not selected
Selecting bearing display and changing sources:
1) Press the PFD Softkey.
2) Press a BRG Softkey to display the desired bearing pointer and information window with a NAV source.
3) Press the BRG Softkey again to change the bearing source to GPS.
4) Press the BRG Softkey a third time to change the bearing source to ADF.
5) To remove the bearing pointer and information window, press the BRG Softkey again.
DME INFORMATION WINDOW
NOTE: Refer to the Audio Panel and CNS Section for information on tuning the radios.
The DME Information Window (labeled ‘DME’; see Figure 2-20) is displayed above the BRG1 Information
Window and shows the tuning mode (NAV1, NAV2, or HOLD), frequency, and actual DME distance. When
a signal is invalid, the distance is replaced by “–.– – NM”.
Displaying the DME Information Window:
1) Press the PFD Softkey.
2) Press the DME Softkey to display the DME Information Window above the BRG1 Information Window.
3) To remove the DME Information Window, press the DME Softkey again.
Figure 2-20 HSI with Bearing and DME Information
Bearing 2 Information Window
No
Waypoint
Selected
Pointer
Icon
Bearing
Source
Bearing 1 Information Window
Pointer
Icon
Distance to
Bearing Source
Bearing
Source
Bearing 2
Pointer
Bearing 1
Pointer Frequency
Tuning Mode
Distance
Station
Identifier
DME Information Window