Garmin G1000 Piper PA32 - Manual (Page 310)

Garmin G1000 Pilot’s Guide for Piper PA32 190-00692-00 Rev. B 6-30
HAZARD AVOIDANCE
6.2 STORMSCOPE WX-500 SERIES II SENSOR
NOTE: The Stormscope system is not intended for hazardous thunderstorm penetration. Weather information
on the G1000 MFD is approved for weather avoidance only. Refer to the WX-500 User’s Guide for a detailed
description of Stormscope operation.
The following pages can display Stormscope data:
• PFD Inset Map • AUX - Trip Planning Page
• Stormscope Page • Nearest Pages
• Navigation Map
To display Stormscope data on any map besides the Stormscope Page, press the MAP Softkey (or the INSET
Softkey for the PFD Inset Map), then press the STRMSCP Softkey. These pages can also display cell or strike data
using the yellow lightning strike symbology shown in Table 6-4.
Lightning Age Symbol
Strike is less than 6 seconds old
Strike is between 6 and 60 seconds old
Strike is between 1 and 2 minutes old
Strike is between 2 and 3 minutes old
Table 6-4 Lightning Age and Symbols
SETTING UP STORMSCOPE ON THE NAVIGATION MAP
Setting up Stormscope options on the Navigation Map:
1) On the Navigation Map Page, press the MENU Key.
2) With ‘Map Setup’ selected (Figure 6-37), press the ENT Key.
3) Turn the small FMS Knob to display the group selection window. Turn the small FMS Knob to select ‘Weather’
(Figure 6-38), and press the ENT Key.
4) Turn the large FMS Knob to highlight and move between the product selections.
5) When an item is highlighted, turn the small FMS Knob to select the option.
6) Press the ENT Key.
7) Press the FMS Knob to return to the Navigation Map Page.