Garmin G1000 Piper PA32 - Manual (Page 61)

190-00692-00 Rev. B Garmin G1000 Pilot’s Guide for Piper PA32 2-11
FLIGHT INSTRUMENTS
Adjusting the Selected Course:
Turn the CRS Knob to set the Selected Course (for each PFD).
Press the CRS Knob to re-center the CDI and return the course pointer to the bearing of the active waypoint or
navigation station (see OBS Mode for adjusting a GPS course).
The heading displayed on the HSI and all other navigation angles (track, heading, course, bearing) are
magnetic when the NAV ANGLE is set to ‘Magnetic’ on the AUX - System Setup Page. When ‘True’ is selected,
all navigation angles and the HSI display a ‘T’ next to the angle value (Figure 2-17). When an approach
referenced to true north has been loaded into the flight plan, the system generates a message alerting the pilot
to switch the NAV ANGLE setting to ‘True’ at the appropriate time.
Figure 2-17 Heading and Course Indications (True)
Changing the navigation angle setting:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight ‘Nav Angle’ in the ‘Display Units’ box (Figure 2-18).
4) Turn the small FMS Knob to highlight the desired setting and press the ENT Key.
Figure 2-18 System Setup Page,
Navigation Angle Settings