AASTRA BluStar 8000i BAS-Mode Administrator Guides EN - Manual (Page 17)

Software Installation and Network Configuration
41-001391-00 Rev 03 – 04.2012 2-4
On the BluStar Application Server Configuration menu, use the up and down arrow keys as necessary to select Network
Configuration, then press Enter. The Select Configuration Option menu displays.
Three different types of network configuration are supported by the BluStar 8000i :
• Single Node (Standalone)
Choose this option if you want to configure the BluStar 8000i as a stand-alone Application Server. Proceed to the Sin-
gle Node (Standalone) configuration procedure on page 2-5 .
• Master Node (High-Availability)
Choose this option if you wish to configure the BluStar 8000i as the Master Node for a High-Availability pair. Continue
with the
Master Node (High Availability) configuration procedure on page 2-6 .
• Slave Node (High Availability)
Choose this option if you wish to configure the BluStar 8000i as the Slave Node of a High-Availability pair. Continue
with the
Slave Node (High Availability) configuration procedure on page 2-7 .
Notes:
• Network Configuration must be completed before attempting to perform any other operation listed on the Server
Configuration menu.
• Do not attempt to configure the networking parameters by directly editing any system files. You must use the Net-
work Configuration operation provided via the menu to configure the networking parameters for this platform.
• After configuring the BluStar Application Server Software, do not alter the BAS IP address or hostname using./vcon-
fig. These settings should be changed using the BluStar Application Server Web UI. Please refer to System Settings on
page 8-14 for details.
Note:
A Master Node must already have been configured prior to choosing the Slave Node option.