AASTRA BluStar 8000i BAS-Mode Administrator Guides EN - Manual (Page 18)

Software Installation and Network Configuration
2-5 41-001391-00 Rev 03 – 04.2012
Single Node (Standalone)
1. Select Single Node (Standalone) and press Enter to continue.
The BluStar Application Server Network Configuration menu displays:
2. Using the up and down arrow keys to select items on the menu, and the Enter key to edit the desired setting, enter
the following information:
Primary Interface Type
Specify the interface type. E100 is only option available.
Primary IP Address
Enter the server primary IP address.
Primary Netmask
Enter the server primary netmask.
Secondary Interface Type
Enter the server secondary interface type (if applicable).
Secondary IP Address
Enter the server secondary IP address (if applicable).
Secondary Netmask
Enter the server secondary netmask (if applicable).
Hostname
Enter a name for the server in fully qualified form (e.g., servername.mycompany.com) (Leave blank or None if not
applicable).
Primary Name Server
Enter the IP address of the Primary Name Server (if applicable).
Secondary Name Server
Enter the IP address of the Secondary Name Server (if applicable).
Default Gateway
Enter the IP Address of the default gateway (if applicable).
Time Server
The server contains a built-in NTP server. BluStar 8000i terminals synchronize time with the server. This option allows
you to configure the server to synchronize its time with an external time server by specifying either the IP Address
or fully qualified hostname of an external network time server.
3. When finished entering your server’s network configuration information, select Apply Configuration and press Enter
to restart the network services and enable the network device. When the BluStar Application Server V (ver) network
configuration successful! message displays, press Enter to return to the BluStar Application Server Configuration
menu.
Note:
After applying the configuration, do not change the network configuration by directly editing configuration files.
4. Continue with Network Configuration on page 2-3 .