AASTRA 600c_d for OpenCom 1000 User Guide EN - Manual (Page 43)

37
Basic functions
Settings for other alarm parameters
Alarm number
If the SOS emergency number is predefined by the system, this menu item is not displayed.
If you always store the SOS emergency number preceded by the R-key feature (enquiry / hold), the
emergency call can also be made during a call (depending on the system / and handset – see
above). To enter the R-key feature, press the #-key three times (see also page 24).
Alarm auto answer
If this function is activated, a call is answered automatically from any call number during the pre-
alarm.
If the function is deactivated and an incoming or existing call is in progress during the pre-alarm, the
alarm call number is dialled at the end of the pre-alarm.
Regardless of the setting, calls from the alarm number or SOS emergency number are answered
automatically and the pre-alarm is terminated.
Alarm tone
The pre-alarm can be sounded with or without an alarm tone on the handset. If the alarm tone is
activated, the signalling volume increases progressively.
Vibrator
You can set whether the pre-alarm should be made with or without vibrator call.
Repeat alarm
This is the amount of time after which a new pre-alarm is made followed by the dialling of the alarm
call number (for instance because the dialling of the alarm call number was cancelled by the sys-
tem).
Handsfree in alarm
You can specify whether the alarm call can be made in handsfree or handset operation. This setting
also applies to the emergency call using the SOS / emergency call key.
Several alarm types activated simultaneously
Avoid simultaneously activating the three types of sensor alarm where very short delays and repeats
are set and the pre-alarm is possibly deactivated. As a result of the simultaneous triggering of the
alarm call it may no longer be possible to access the menu (to deactivate an alarm type). In this situ-
ation place the handset in the charger cradle and leave it there. Then make the settings.