AASTRA 600c_d for OpenCom 1000 User Guide EN - Manual (Page 90)

84
Devices menu
Infos Slowly flashing red LED for a new entry, e.g. in the call
list.
Handsfree Lights green LED when the loudspeaker is activated.
Alarm clock Slowly flashing red LED when the alarm time
is signalled.
Appointment Slowly flashing red LED when the appointment
is signalled.
List access
The caller list and/or redial list are normally administered on your handset (setting: Local). If
a list is also managed in the communication system (setting: PBX), you can select which list
you want to display. Select Automatic to ensure that the device always uses the list (where
available) from the PBX communication system. If the list is not available, the automatic
selection remains on Local. Selecting PBX (or Automatic / PBX) makes sense if your handset
is operating in parallel with corded phones. This ensures that both devices have access to
the same list and that any changes made are visible on both devices.
Device options
Silent charging
The handset does not give an acoustic signal for any calls when it is in the char-
ger cradle. When you take it out, calls are acoustically signalled again. The calls
are recorded in the call list.
“Silent Charging“ will not apply when the handset is charged via the USB con-
nector.
Auto. key lock
If this option is active, the keyboard is automatically locked after approx. 60 sec
if no key is pressed.
Auto. answer (charger)
If this feature is active, the handset automatically answers a call if it is taken out
of the charger cradle.
Auto. answer (call)
With this feature the handset answers a call automatically. Only activate this
feature if your work requires it as it is then possible for the caller to listen in
unnoticed. For safety reasons Auto answer is initiated using 3 attention tones
and its actuation is signalled during the call by the rapidly flashing green LED.
This feature is useful if you need to be informed immediately about important
matters (e.g. when on standby). This feature also simplifies procedures when
operating the handset with a headset. Press Change to activate or deactivate.
You can set the following options:
Time
Sets the amount of time after which Auto answer should be activa-
ted: 0 ... 20 seconds.