AASTRA 600c_d for OpenCom 1000 User Guide EN - Manual (Page 94)

88
alarms, pressing any key on the device resets the delay – e.g. if you
are navigating the menu.
Sensibility
Allows you to set the sensitivity (low, medium, high). This allows
you to adapt the sensor to the different movements (e.g. ways of
walking) of the surveillance personnel:
•
Low sensibility means: Slow movements are enough to reset
the delay once again.
• High sensibility means: Only rapid (jolting) movements will
reset the delay.
Please switch Vibra call off in the Ringer settings (see page 72) if
you wish to use the no movement alarm.
Escape alarm Use Change to switch the escape alarm on or off.
Alarm in conversation
Switch off this feature to prevent alarm activation by mistake
during an active call.
Delay Allows you to set the amount of time the handset can be in rapid
movement before a pre-alarm is triggered (1 s … 75 s).
Sensibility
Allows you to set the sensitivity (low, medium, high). This allows
you to adapt the sensor to the different movements (e.g. running
movement) of the surveillance personnel:
•
Low sensibility means: The alarm is triggered only by rapid or
jolting movements.
• High sensibility means: Slower movements are enough to
trigger the alarm.
Please switch Vibra call off in the Ringer settings (see page 72) if
you wish to use the escape alarm.
Repeat alarm
Use Change to switch the repetition of an alarm on or off.
Repeat time
This is the amount of time after which a new pre-alarm is made followed by the
dialling of the alarm call number, for instance because the dialling of the alarm
call number was cancelled (5 s... 240 s).
Reset to default
You can reset different areas of your settings to the status they had on delivery.
Personal directory
You can delete your phone book entries after a confirmation prompt.
Devices menu