Ohaus I150-S Indicator - Manual (Page 16)

16
MAIN MENU MAIN MENU MAIN MENU MAIN MENU MAIN MENU
Displayed Submenu Displayed Submenu Displayed Submenu Displayed Submenu Displayed Submenu Description Description Description Description Description
Setup and scale submenus are used to
configure the I150 software for the load
receiver(s) being used and to display
weight measurements according to your
requirements.
Calibration submenu is used to adjust
load receiver zero potentiometers and
to calibrate the I150.
RS-232 submenu is used to configure
the interface communication parame-
ters.
End is used to exit the menus and
SAVE CHANGES .
Only one menu selection will be displayed
at a time. Use the UPUP and DOWN keys
to step through the menu selections. By
repeatedly pressing UPUP or DOWN ,
you can view all of the selections on the
menu.
When you select one of the submenus,
you gain access to a specific group of
operating parameters.
How To Use Menus How To Use Menus How To Use Menus How To Use Menus How To Use Menus
When initially setting up the I150, it is
recommended to view all of the parame-
ters. Once configured, you can view or
change a particular parameter while by-
passing others. The following procedures
apply whenever you use menus.