Ohaus I150-S Indicator - Manual (Page 8)

8
6. After the connections have been
made, fasten two cable ties (included
in the accessory kit) around the power
cord as shown in the diagram. The
cable ties secure the power cord so it
cannot be pulled out of the enclo-
sure.
7. Tighten the seal bushing until resis-
tance is felt against the cable. Turn
the cap nut an additional full turn to
secure the cable.
Cable Ties
Load Receiver
#2
Load Receiver
#1
Load Receiver Connections Load Receiver Connections Load Receiver Connections Load Receiver Connections Load Receiver Connections
Using a small screwdriver, connect the
load cell cable to TB1 located on the main
circuit board inside the enclosure as fol-
lows (see diagram):
1. Pass the cable from the load
receiver(s) through one of the two
liquid tight connector(s) seal bush-
ings on the lower left of the enclo-
sure.
2. Make the connections according to
the markings on the circuit board.
3. After the connections have been
made, tighten the seal bushing until
resistance is felt against the cable.
Turn the cap nut an additional full
turn to secure the cable.
NOTE: Remote sensing is available only
on load receiver #1. Load receiver #2 may
not be used.
For Ohaus LB, PL and WB platforms,
leads are color coded as follows:
Black: EXC (-) Green: EXC (+)
White: SIGNAL (-) Red: SIGNAL (+)
Yellow: SENSE (-) Blue: SENSE (+)
For Ohaus WBS platforms:
Black: EXC (-) Red: EXC (+)
White: SIGNAL (-) Green: SIGNAL (+)
SENSE connections from Load
Receiver #1. (Load Receiver #2 IS
NOT USED)