Ohaus I150-S Indicator - Manual (Page 64)

64
The following will be output via the
RS-232 interface:
XX:XX:XX (time) *
XX/XX/XX (date) *
ID: XXXXXX (ID code)
IN: X.XXXX lb (original load)
OUT: X.XXXX lb (current load)
NET: X.XXXX lb (IN - OUT)
* Only if time and date are enabled.
NOTE: In in-out operation, retrieving an
ID code causes it to be cleared from
memory.
Viewing ID Codes Viewing ID Codes Viewing ID Codes Viewing ID Codes Viewing ID Codes
To view currently stored ID codes,
press RECL without entering an ID code.
If ID codes have been stored, the first
available code will be displayed for
about five seconds. To view all of the
codes,
repeatedly press RECL before the
five second timeout.
If no ID codes have been stored, the
word “nonE” will be displayed briefly.
Clearing ID Codes Clearing ID Codes Clearing ID Codes Clearing ID Codes Clearing ID Codes
To clear ID codes stored with tare and
average piece weight values:
1. Display the desired ID code as ex-
plained above.
2. Press CLRR while the ID code is
displayed.
The ID code and stored data will be
erased from memory.
STORE STORE STORE STORE STORE
RECALL RECALL RECALL RECALL RECALL
STORE STORE STORE STORE STORE
RECALL RECALL RECALL RECALL RECALL
- / + - / + - / + - / + - / +
CLR CLR CLR CLR CLR