Ohaus I150-S Indicator - Manual (Page 67)

67
RS-232 COMMAND TABLE (Continued) RS-232 COMMAND TABLE (Continued) RS-232 COMMAND TABLE (Continued) RS-232 COMMAND TABLE (Continued) RS-232 COMMAND TABLE (Continued)
N same effect as pressing GROSS/NET button
P PRINT; same effect as pressing PRINT button
/XXX.XXX/PL download non-printing low limit in current calibration unit
/XXX.XXXAA/PL download non-printing low limit in designated unit “AA”;
AA = kg, lb, cs, oz or pc (may be upper or lower case characters)
/XXX.XXX/PH download non-printing high limit in current calibration unit
/XXX.XXXAA/PH download non-printing high limit in designated unit “AA”;
AA = kg, lb, cs, oz or pc (may be upper or lower case characters)
EscR RESET; same as selecting reset in scale submenu; resets
scale submenu parameters to factory default settings
iS set stable-only print feature to “i” where i = 0 (off) or 1 (on)
EscS store menu settings in memory; operates only when I150 is
not in setup mode
V output version number of software installed in I150
J start filling/unfilling
K stop filling/unfilling
Z RE-ZERO; same effect as pressing ON/ZERO button
NOTES: Polarity sign (+ or -) may be included in all floating point data. For example,
numeric tare entry may be sent as “-10.00kg”.
Only commands listed in this table will be acknowledged by the I150. Other
characters will be ignored; no error message will be returned.