Ohaus I150-S Indicator - Manual (Page 6)

6
UNPACKING UNPACKING UNPACKING UNPACKING UNPACKING
Verify that your indicator was shipped
with the following items:
•
I150-P or I150-S indicator
•
power cord
•
instruction manual
•
warranty card
•
an accessory kit including:
-
two hole plugs
- one calibration seal
- one capacity label sheet
- one screwdriver
- one 5/16" #6-32 hex nut
- two cable ties
- four shorting jumpers
- one press-on “APW/PCS” label
- one setpoint connector
Label
Hex Nut
Hole Plugs Cable Ties
Power
Cord
Calibration Seal
Shorting Jumpers
Setpoint
Connector
Screw Driver
I150 Indicator
WARNING WARNING WARNING WARNING WARNING
•
To avoid shock hazards, always be certain that the power cord is
disconnected from the wall outlet BEFORE opening the enclosure.
•
Even though the I150 may have been switched OFF, high voltage is
present inside the enclosure as long as power cord is connected to a power
source.
•
DO NOT use any other type of power cord other than the one that was
furnished with the indicator.
•
DO NOT create a safety hazard by defeating the grounding feature.