Retain zero data end, Retain zero data – Ohaus I150-S Indicator User Manual
Page 35
35
Retain Zero Data
Retain Zero Data
Retain Zero Data
Retain Zero Data
Retain Zero Data
“rEtAin” can be set to ON or OFF. When
set to ON, zero data is saved in perma-
nent storage any time the indicator is
rezeroed. The current weighing unit and
current load receiver (1 or 2) are also
saved.
CAUTION:
CAUTION:
CAUTION:
CAUTION:
CAUTION: Set this parameter to ON only
when needed. Storing zero data reduces
the life of the EEPROM (storage chip).
Expected life of the EEPROM under nor-
mal conditions is 50,000 write cycles and
20 years data retention.
To set this parameter ON or OFF:
Press
UPUP
or
DOWN
to display the
desired setting, then press
ENTER
to return to the scale submenu.
End
End
End
End
End
You must select “End” to exit the scale
submenu.
1.
Press
ETER
when “End” is displayed.
2.
“SCALE” will be displayed and the
main menu will be returned.
NOTE: Scale submenu parameter set-
tings are permanently stored in memory
when you use “End” to exit from the Main
menu, or when the OFF key is pressed.
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER