Ohaus I150-S Indicator User Manual
Page 38
38
3.
The display will show “buSY” while
the I150 reads the first calibration
point, and then show “C XXXX” indi-
cating the value of a load which must
be applied to the load receiver.
•
If the value is greater than 4 digits,
the display will show “C Pt” in
place of the value.
•
If 3-point linearization is being per-
formed (a linearization point was
selected in the “SEtUP” submenu),
and the value is greater than 4
digits, then “L Pt” will be displayed.
4.
Apply the required load to the load
receiver, and then press
ENTER
.
5.
The display will again show “buSY”
while the I150 reads the calibration
point.
-
If span calibration is being per-
formed (no linearization point
was selected in the “SEtUP” sub-
menu), proceed to step 9.
-
If 3-point linearization is being
performed (a linearization point
was selected in the “SEtUP”
submenu), continue with step 6.
6.
The display will show “C XXXX” indi-
cating the value of the next load
which must be applied to the load
receiver. “C Pt” will be displayed if
the value is more than 4 digits.
OR
OR
OR
ENTER
ENTER
ENTER
ENTER
ENTER