Ohaus I150-S Indicator - Manual (Page 18)

18
SETUP SUBMENU SETUP SUBMENU SETUP SUBMENU SETUP SUBMENU SETUP SUBMENU
The Setup submenu is used to view or change the parameters outlined in the following
table. The table shows the sequence in which the parameters appear on the display.
SETUP SUBMENU SETUP SUBMENU SETUP SUBMENU SETUP SUBMENU SETUP SUBMENU
Displayed Parameter Displayed Parameter Displayed Parameter Displayed Parameter Displayed Parameter Description Description Description Description Description
sets I150 for Legal for Trade operation
enables/disables load cell sensing
configures I150 for 1 or 2 load receivers
specifies allowable percentage of max
load that can be zeroed out
specifies the weighing unit that will be
used for calibration
specifies full scale capacity
specifies increment of calibration unit in
which indicator will display weight
specifies the span calibration point
specifies the linearization point
used to exit the Setup menu
To select a parameter,
Repeatedly press UPUP or DOWN to
display the desired parameter, then press
ENTER .
ENTER ENTER ENTER ENTER ENTER