Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) User Manual
Page 13
96801 v.9.0
13
Figure 19 Dodge (06-07) Shown
19.
Route the RJ12 cable to reach the
Docking Station and connect it to the
left most receptacle on the bottom of
the Docking Station. See Figure 19.
Note: You may need to remove and or
loosen dash panel or covers to install
the RJ12 cable between dash crevice
or behind dash panels. See Figure 19
WARNINg: ThE ChARgINg CABLE
oN ThE DoCKINg STATIoN IS
DESIgNED To SUPPLY A CoNSTANT
LoW-VoLTAgE PoWER SoURCE
(+5VDC) To ThE BANKS PoWERPDA
AND IS “LIVE” AS LoNg AS ThE
SYSTEM’S oBD II INTERFACE CABLE
IS CoMPLETELY INSTALLED AND
ThE RJ12 CoNNECToR IS PLUggED
INTo ThE DoCKINg STATIoN.
ALThoUgh ThIS ChARgINg CABLE
IS ShoRT AND ITS CIRCUITRY IS
FUSE-PRoTECTED, ThE USER IS
EXPECTED To TAKE APPRoPRIATE
MEASURES To PREVENT SMALL
ChILDREN AND/oR PETS FRoM
CoNTACT WITh ANY PART oF ThIS
SYSTEM.
20.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash. Secure all
wiring under the hood away from heat
sources or sharp edges.
21.
Your Docking Station is now
installed and is ready for the Banks
PowerPDA. Install the Banks PowerPDA
into the Docking Station. Be sure the
Banks PowerPDA is completely seated
in the Docking Station against the
lower support bracket.
22.
Plug the Docking Station’s
charging cable into the charging
receptacle on the lower edge of the
Banks PowerPDA.
NOTE: There may be a snug fit when
installing the Banks PowerPDA into
Figure 18