Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 14)

14
96801 v.9.0
the Docking Station. Take care not to
force this process.
(Universally Mounted docking
stations) Skip to Section 4.
Ford (’03-04)
23.
Locate the self-drilling screw
supplied in your kit.
24.
Install the screw through the
large access hole in the bottom of the
Docking Station.
Doing this will put a permanent
hole in the dashboard panel. Be
certain of the location of the
Docking Station before installing
the screw.
Note: The Docking Station must be
connected to the previously installed
Banks PowerPDA-compatible Six-Gun
tuner via an RJ12 cable. If your Six-Gun
tuner is not installed, refer to the Six-
Gun tuner owner’s manual to install
the tuner before proceeding.
25.
Remove the fuse access panel
below the steering column. It is
secured by four 1 ⁄
4
-turn plastic screws.
26.
Remove the smaller dash panel
immediately to the right as shown in
Figures 20 and 21. Unclip it by pulling
in the area shown in the picture.
27.
Locate the RJ12 cable from your
Six-Gun Wiring harness and route it
to the bottom of the Docking Station
behind the panels you’ve just removed.
28.
connect the RJ12 cable to the
left-most receptacle on the bottom of
the Docking Station.
Warning: The charging cable on
the Docking Station is designed
to supply a constant low-voltage
power source (+5VDC) to the
Banks PowerPDA and is “live”
as long as the system’s oBD II
interface cable is completely
installed and the RJ12 connector
is plugged into the Docking
Station.
Although this charging cable is
short and its circuitry is fuse-
protected, the user is expected
to take appropriate measures
to prevent small children and/or
pets from contact with any part
of this system.
29.
Refit the dash panel by carefully
snapping it back into place. Refit
the fuse access panel using the four
fasteners removed earlier. Tuck any
excess cable behind the panels for
a clean appearance. See Figure 21.
30.
Your Docking Station is now
installed and is ready for the Banks
PowerPDA. See Figure 22. Install the
Banks PowerPDA into the Docking
Station.
Be sure the Banks PowerPDA is
completely seated in the Docking
Station against the lower support
bracket.
31.
Plug the Docking Station’s
charging cable into the charging
receptacle on the lower edge of the
Banks PowerPDA.
NOTE: There may be a snug fit when
installing the Banks PowerPDA into
the Docking Station. Take care not to
force this process.
(Ford 03-04) Skip to Section 4
Ford (’05-07)
Note: The Docking Station must be
connected to the previously installed
Banks PowerPDA-compatible Six-Gun
tuner via an RJ12 cable. If your Six-
Gun tuner is not installed, refer to