Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) User Manual
Page 31
96801 v.9.0
31
Figure 50
Figure 51
Figure 52
Screen 1 of the ‘On Screen Alerts’
menu edits the ‘Exhaust Gas
Temperature Alert Set Point’.
5.
Touch the ‘Increase’ button to
increase the temperature set point.
6.
Touch the ‘Decrease’ button to
decrease the temperature set point.
The increments are set at 25 degrees.
7.
Touch the ‘Save’ button to save the
setting.
8.
Touch the ‘Next’ button to edit
the next parameter. Follow the
same procedure listed above for the
remaining alerts.
9.
Touch the ‘Done’ button to return
to the System Menu.
10.
Touch the ‘Back’ button to return
to the ‘System Monitor’ screen.
NOTE: In the event an alert set point
is reached an audible alarm will sound
off and the Status Indicator will display
an icon relative to the associated alert.
See Figure 52. The alarm will turn
off once the associated parameter is
below its alert set-point. The Status
Indicator will then return to ‘OK’.
-END, SEcTION 11-