Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- PowerPDA Ford (03-09), Chevy (01-08), Dodge (03-07) - Manual (Page 7)

96801 v.9.0
7
3.
In the ‘copy From’ drop down menu
select “card”. See Figure 6. The ‘copy
To’ selection will automatically change
to “Device”. See Figure 7. select on
the “Banks” icon, if it is not selected or
there is more than one item in the list.
Touch the “copy” button. See Figure
8. A dialog box will appear, indicating
the Banks PowerPDA is copying the
software from the SD card. Once
completed, press the “Done” button.
4.
Select the drop-down menu in the
upper right hand corner of the screen.
Touch the button labeled ‘All’. The
Banks PowerPDA software is now
installed. You may now remove the SD
card from its slot.
5.
To start the Banks PowerPDA
software touch the icon called
“Banks”. See Figure 9.
-END, SEcTION 2-
Note: This system has been
designed for use with the Palm
Tungsten E2 PDA.
Warning: The PDA may be
susceptible to damage as a result
of extended exposure to sunlight,
heat or extreme cold. It is highly
recommended that the PDA
be removed from its mounting
location if the vehicle will be
subjected to high concentrations
of sunlight, heat or cold for
an extended period of time.
gale Banks Engineering is not
responsible for damage to PDAs
resulting from exposure conditions.
Locate the Docking Station in your kit.
The mounting location of the Docking
Station is vehicle specific. Only Dodge
(‘06-07), chevy/GMc (01-08) & Ford
(’08-09) have a universal fitting mount.
Make sure to do a dry pre-fit before
permanently mounting. For mounting
locations, refer to the following
figures:
Figure 16 – Dodge (‘03-05)
Figure 19 – Dodge (‘06-07),
–chevy/GMc (01-08) LB7-LMM
– Ford (’08-09)
Figure 22 – Ford (’03-’04)
Figure 23 – Ford (’05-07)
Note: In cold climates, best results will
be obtained if the vehicle’s heater is
run to bring the inside temperature up
to “room temperature” (at least 68°F).
1.
clean mounting area with isopropyl
alcohol or similar residue-free cleaning
agent to prepare the surface for the
adhesive tape.
Figure 9
Section 3
MoUNTINg ThE DoCKINg STATIoN AND CoNNECTINg
ThE BANKS PoWERPDA