06 jeep wrangler tj super-scoop, Hood cut template – Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Sidewinder Jeep Turbo Jeep 4.0L I-6 models '05-06 User Manual
Page 13
1.0"
EDGE OF HOOD LATCH REFERENCE LINE
LOWER HOOD CREASE
BOTTOM OF HOOD REFERENCE LINE
UPPER HOOD CREASE
CREASE AROUND HOOD LATCH
3/8" DRILLED MOUNTING HOLE
3/8" DRILLED MOUNTING HOLE
3/8" DRILLED MOUNTING HOLE
3/8" DRILLED MOUNTING HOLE
1-1/2" INTAKE HOLE
INTAKE OPENING REFERENCE LINE
from template (arch shape). Position
intake hole by aligning outer edge with
outer edges of all five 1¹/₂" holes. Ensure
bottom edge of intake hole is parallel
to bottom edge of hood. Secure with
masking tape and trace along outer edge
to create intake hole shape on hood.
See Figure 28
8. Use a pneumatic reciprocating saw
or similar cutting implement to cut along
inside edge of trace, connecting all five
outer edges of 1¹/₂" holes. Deburr all
edges and carefully remove rags, trap-
ping all debris. Use touch-up paint to
cover raw metal edge. See Figure 28
9. Center Super-Scoop
®
(P/N
41565) in intake hole with bot-
tom edge parallel to bottom edge of
hood. Mark mounting locations on
Super-Scoop
®
through inside of hood.
See Figure 29
10. Use stepped drill bit to drill four ³/₈"
holes in Super-Scoop
®
at marked mount-
ing locations. Deburr all edges.
!
CAUTION: ONLY drill through inside
wall of Super-Scoop
®
.
11. Use four push type retainers
(P/N 92023) to mount Super-Scoop
®
on hood. Install edge seal (P/N 93141)
onto inside edge of Super-Scoop.
®
See Figure 30
96312 v.1.0
13
‘ 05-06 Jeep Wrangler TJ
Super-Scoop
®
Hood Cut Template