Sidewinder, Turbo system installation procedure – Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Sidewinder Jeep Turbo Jeep 4.0L I-6 models '05-06 User Manual
Page 5
96312 v.2.0
5
a shorter drive belt from your
local automotive supply shop.We
have found that a 91.0” (2310 mm
6PK2310 or 910K6 or equivalent)
fits appropriately with aftermar-
ket power steering pump pulleys.
Fuel Injectors
1.
Disconnect ground cable from bat-
tery before beginning work. If there are
two batteries, disconnect both.
2.
Disconnect manifold air pressure
(MAP) sensor connector, throttle posi-
tion sensor (TPS) connector, and idle
air control (IAC) valve connector from
throttle body. See Figure 2
3.
Disconnect throttle and cruise con-
trol cables from throttle lever.
4.
Remove throttle body by removing
four bolts and lifting straight up. Cover
intake manifold inlet with a cap or
clean rag.
5.
Remove throttle cable/cruise
control cable bracket by removing
two bolts. See Figure 2
10mm socket
!
CAUTION: Fuel system may
be under pressure!
6.
Using compressed air source, blow
any debris away from fuel injectors to
prevent any foreign objects from falling
into intake manifold once fuel injec-
tors are removed. Disconnect fuel injec-
tor connectors. Remove injector rail by
removing two nuts and two studs.
10mm deep socket
Sidewinder
®
Turbo System Installation Procedure
Radiator Support Rod
Front
PCV Hose
Ignition
Coil Pack
IAT Sensor
Figure 1
!
NOTE: If you are not going
to weld oil return bung onto
the oil pan yourself, we recom-
mend starting by removing the
oil pan so that it can be welded
by a qualified welder as you
proceed with installation. See
Oil Pan and Exhaust Removal
and Turbocharger Oil Return on
pages 10 and 15.
!
NOTE: The provided drive
belt will only work for stock con-
figuration front engine acces-
sory pulleys. If your vehicle is
equipped with an aftermarket
power steering pulley or other
aftermarket pulley with a diam-
eter smaller than the stock
equivalent, you must purchase