Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Sidewinder Jeep Turbo Jeep 4.0L I-6 models '05-06 - Manual (Page 21)

96312 v.2.0
21
Boost Gauge
1.
Using compression ferrule
installed in throttle body, install boost
gauge kit. Refer to provided boost
gauge kit installation instructions for
full procedure.
Flash Tune
!
NOTE: Banks Sidewinder ®
Tune must be successfully load-
ed before running vehicle.
1. Run the inTune auto update soft-
ware by connecting inTune to your
computer with provided USB cable.
2.
Software should run automatical-
ly. If it does not, click Run InTune.exe
in popup window. If there is no popup
window, click the Windows icon in
bottom left corner. Then, click on
Computer (Windows 7, Vista) or My
Computer (Windows XP) in right hand
column. In new window, double click
on drive labeled CD Drive Diablosport.
Finally, double click InTune to run
software.
3.
If an update is available, you will
be prompted to not unplug the device,
click OK. The update will begin, do not
unplug device until it has restarted.
4.
Connect inTune to vehicle’s diag-
nostic port using OBDII cable.
!
NOTE: Diagnostic port is
located below steering column,
on left hand side.
After loading screen, the Main Menu
will appear with the following selec-
tion options: Tune Vehicle, Scan Tool,
and Settings. See Figure 35
5. To flash tune vehicle, select Tune
Vehicle from Main Menu. Then, select
Write Vehicle. See Figure 36
6. Wait for prompt, then turn key
to on position without starting the
vehicle. See Figure 37
Select Diablo Tuning and then Banks
Sidewinder
® Turbo. Select green check
mark to confirm tune or select red “X”
to go back. See Figures 38 & 39
!
NOTE: Device will auto-
matically backup factory tune.
See Figure 40
7.
A prompt will ask if you want to
modify tune (tire sizes, gear ratios,
etc.). To modify tune, select the green
check mark or to install default tune
select red “X”. See Figure 41
8.
Select the green check mark to
install Banks Sidewinder Turbo tune.
9.
Cycle key position when prompt-
ed and select green check mark to
continue. See Figures 42 & 43
10.
Device will begin installing
tune. Once tune is installed, cycle
key position when prompted and
select green check mark to continue.
See Figure 44
11.
Select Continue after success-
ful install to return to Main Menu or
unplug inTune.
Figure 41 Figure 43
Figure 42 Figure 44