Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Sidewinder Jeep Turbo Jeep 4.0L I-6 models '05-06 User Manual
Page 18
18
96312 v.2.0
mounting hole centers and five intake
hole centers for drilling locations.
Carefully remove template from hood
without damaging it. See Figure 27
5.
Using a stepped drill bit, drill a ³/₈"
hole in four mounting hole locations
(outside center marks). Drill a ⁵/₁₆"
starter hole in five intake hole loca-
tions (inside center marks) to guide
1¹/₂" hole saw. Take care while drilling
and cutting and beware of surround-
ing components.
!
CAUTION: Use eye and ear
protection while drilling and
cutting.
6.
Use a 1¹/₂" hole saw to cut five
intake holes where the ⁵/₁₆" starter
holes were made. See Figure 28
7.
Use scissors to fully cut intake
hole from template (arch shape).
Position intake hole by aligning outer
edge with outer edges of all five
1½” holes. Ensure bottom edge of
intake hole is parallel to bottom
edge of hood. Secure with masking
tape and trace along outer edge to
create intake hole shape on hood.
See Figure 28
8.
Use a pneumatic reciprocating
saw or similar cutting implement to
cut along inside edge of trace, con-
necting all five outer edges of 1¹/₂"
holes. Deburr all edges and carefully
remove rags, trapping all debris. Use
touch-up paint to cover raw metal
edge. See Figure 28
9.
Center Super-Scoop
®
(P/N
41565) in intake hole with bottom
edge parallel to bottom edge of
hood. Mark mounting locations on
Super-Scoop
®
through inside of hood.
See Figure 29
10.
Use stepped drill bit to drill four
³/₈" holes in Super-Scoop
®
at marked
mounting locations. Deburr all edges.
!
CAUTION: ONLY drill through
inside wall of Super-Scoop
®
.
11.
Use four push type retainers
(P/N 92023) to mount Super-Scoop
®
on hood. Install edge seal (P/N 93141)
onto inside edge of Super-Scoop.
®
See Figure 30
Edge seal
Push type
Retainers
Figure 29
Figure 30