Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Sidewinder Jeep Turbo Jeep 4.0L I-6 models '05-06 - Manual (Page 19)

96312 v.2.0
19
Air Filter and Housing
1. Install air filter housing iso-
lators (P/N 92980) onto fender with
washers (P/N 91102) and Keps
nuts (P/N 91112). Do not tighten.
See Figure 31
2.
Install air filter housing (P/N 41561)
onto isolators with washers and Keps
nuts. Torque all fasteners to 8 lb-ft.
⁷/₁₆" wrench and socket
3.
Install compressor intake tube (P/N
41564) onto compressor using one hose
coupler (P/N 94265) and two worm gear
clamps (P/N 92841). Do not tighten.
!
NOTE: Place coupler and
clamps on compressor (posi-
tion clamps where worm gear is
accessible), then install compres-
sor intake tube.
4.
Install air filter element into air
filter housing with open end towards
compressor intake tube. Use hose
clamp (P/N 92872) to secure air filter
element to compressor intake tube. Do
not tighten.
!
NOTE: Check for clearance
between compressor intake
tube and engine fan shroud. If
necessary, mark where clear-
ance is needed and remove
compressor intake tube.
Trim fan shroud to provide
approximately ³∕
8
” clearance.
See Figure 32
5. Install air filter housing cover (P/N
41562) with one short machine screw
(P/N 91226) in bottom hole and two
long machine screws (P/N 91242) in
top two holes. Tighten compressor
intake tube clamps at compressor inlet,
then the clamp at air filter.
See Figure 33
#3 Phillips, 8mm socket
6.
Install provided 20” length
¹/₂" inner diamter front PCV hose
(P/N 94138) from compressor intake
tube to PCV elbow on top of engine
(towards the front). See Figure 34
7.
Reinstall passenger side radiator
support rod.
Figure 31 Figure 33
Figure 32 Figure 34
Air filter
housing
Isolators
Short
Screw
Compressor
Intake Tube
Engine Fan
Shroud
Front PCV
Hose
Long
Screws