Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Sidewinder Jeep Turbo Jeep 4.0L I-6 models '05-06 - Manual (Page 17)

96312 v.2.0
17
Boost Tube
1.
Install 90º brass barb (P/N 92122)
and pipe plug (P/N 92251) into boost
tube (P/N 42452) with thread sealant.
Install stock IAT sensor into boost
tube. See Figure 26
Figure 26
2.
Install small end of boost tube
using hose coupler (P/N 94253) at
turbo with hose clamps (P/N 92850),
Install large end using hose coupler
(P/N 94276) at throttle body with hose
clamps (P/N 92855). Connect IAT sen-
sor connector.
3. Connect free end of BOV refer-
ence line to BOV barb with spring
clamp (P/N 92775). Use cable ties to
secure line to avoid hot or moving
parts.
4. Install wastegate actuator refer-
ence line (P/N 94123) by pushing it
onto 90º brass barb on boost tube and
on to wastegate actuator barb. Use
cable ties to secure line to avoid hot
or moving parts.
Ram-Air ® Intake &
Super-Scoop ®
!
NOTE: Installing the Ram-Air ®
Intake & Super-Scoop ® requires
that you cut a hole in your
hood. The Banks Sidewinder ®
Turbo System can be run with-
out the Super-Scoop ® ; however
the performance of the Banks
Sidewinder ® Turbo System will
suffer and cannot be guaranteed.
1. Cover entire turbo with clean rag.
Cover any other open ports or electri-
cal connectors.
2. Use scissors to carefully cut
provided template on reference lines
labeled bottom of hood and edge of
hood latch.
!
NOTE: Edge of Hood Latch
Reference Line refers ONLY to
OEM hood latches!
3.
Position template on hood by
aligning bottom of hood reference
line with bottom edge of hood. Then,
align edge of hood latch reference line
with left side of hood latch. Ensure the
upper and lower hood crease refer-
ence lines are aligned with crease in
side of hood and adjust if necessary.
Use masking tape to hold template in
place. See Figure 27
4. Use a center punch to mark four
Figure 25 Figure 27
Figure 28