Grain Systems PNEG-366 - Manual (Page 19)

19
18' Autoflow
Grain Systems, Inc. Assumption, Ill.
SECOND RING
TOP RING
Figure #18
Figure #19
S-3558
Neoprene
Washer
S-7041
Corrugation
Spacer
TD-100667
Wall Bracket
S-7041
Corrugation
Spacer
TD-100667
Wall Bracket
S-3558
Neoprene
Washer
STIFFENER AND BRACKET INSTALLATION
Install the stiffeners on the outside of the bin (as shown in Figure #14) and the wall brackets on the inside of the bin.
The wall brackets are to be positioned with the bracket's top hole matching the first hole up from the horizontal seam
(not counting the horizontal seam). Bracket to sidewall connection using a 3/8" x 1.1/2" bolt (S-2086), head outside,
with a neoprene washer (S-3558) against the wall on the inside, and a corrugation spacer (S-7041).
NOTE: It may be necessary to ream out sidewall holes with a drill and 3/8" bit for easier installation.
REV. 11-20-96