Grain Systems PNEG-366 - Manual (Page 25)

25
18' Autoflow
Grain Systems, Inc. Assumption, Ill.
REV. 11-20-96
FLASHING BOLT INSTALLATION
Install the eave flashing bolts (5/16" x 1.1/4") through the sidewall and tighten first nut. Note at the vertical
sidewall seams, one bolt is turned around to avoid interference with eave flashing (refer to photo).
Eave Flashing Holes
Left bolt on the each vertical
sidewall seam level with the eave
flashing bolts (as viewed from
inside the bin) is to be installed bolt
in, nut out, as shown in the photo
to the right.
Figure #27
EAVE FLASHING INSTALLATION
¬
­
#10 Self-Drilling
Screws (S-280)
­
Floor Flashing Angle
(TD-100654)
¯
Figure #28. Flashing Attachment. 1) Sidewall, 2)
Flashing TD-100648, 3) Floor sheet, 4) 5/16" x 1.1/4" bin
bolt. Note that there is a nut in between the sidewall sheet
and the flashing sheet.
Install the eave flashing centered on the floor sheet (1 per) with the bent edge towards
the sidewall install a fender washer (S-3671) and nut. Screw the flashing to the flashing
angle at the dump hopper opening with 5- #10 self drilling (S-280) screws and screw
the flashing pieces together where they overlap with 3 - #10 self drilling (S-280) screws.