Grain Systems PNEG-366 - Manual (Page 30)

Grain Systems, Inc. Assumption, Ill.
30
18' Autoflow
S-396 3/8" Nuts
S-845 Flatwasher
TD-100039
Sm. Pulley Bracket
Field drill 1/2" dia. hole
Figure #36
12" from center of hole on the overlap
between top sidewall sheet and second
ring sidewall sheet
TD-100089
Pulley Assembly
S-4749 1/2" x 1.1/4"
Shoulder Bolt
TD-100038 Lg.
Pulley Bracket
Bottom edge of top ring
(horizontal seam)
PULLEY ASSEMBLY
Position the pulley assembly to the cross angle in the middle of the center collar assembly. Use a 3/8" x 1" hex
head cap bolt to fasten assembly to the cross angle. Position the pulley in the direction of the desired winch
location on the sidewall.
TD-100022 Pulley Bracket
TD-100089
Pulley Assembly
S-4750 1/2" x 1.1/2"
Shoulder Bolt (Round Head)
S-845 Flatwasher
S-396 3/8" Nut (2)
S-3949 3/8" x 1" Cap Bolt
Figure #35
Field drill (5) 3/8" diameter holes as shown. Attach the pulley assembly with 5/16" x 3/4" bolts with the neoprene on
the inside of the bin.
REV. 11-20-96