Grain Systems PNEG-366 - Manual (Page 28)

Grain Systems, Inc. Assumption, Ill.
28
18' Autoflow
Bolt the sections together to form perforated cone as shown below. Use 1/4" x 5/8" bolts and nuts to attach sections together.
CENTER CONE ASSEMBLY
Side Formed View
Formed Overhead View Flat Overhead View
1/4" x 5/8" Bolts & Nuts
TD-100219
Perforated Cone
Section (6 Required)
Install cone over the center collar. Fasten Cone Assembly with (12) #10 x 3/4" self-drilling screws (S-280).
#10 x 3/4" Self-Drilling Screw
(12 Equally Spaced)
Figure #32
CENTER CONE INSTALLATION
REV. 11-20-96