Rainbow Electronics W90P710CDG - Manual (Page 146)

W90P710CD/W90P710CDG
- 146 -
BITS DESCRIPTIONS
[31:12] Reserved -
[11] TXHA
The Transmission Halted high indicates the next normal packet transmission
process will be halted because the bit TXON of MCMDR is disabled be S/W.
1’b0: Next normal packet transmission process will go on.
1’b1: Next normal packet transmission process will be halted.
[10] SQE
The Signal Quality Error high indicates the SQE error found at end of packet
transmission on 10Mbps half-duplex mode. The SQE error check will only be
done while both bit EnSQE of MCMDR is enabled and EMC is operating on
10Mbps half-duplex mode.
1’b0: No SQE error found at end of packet transmission.
1’b0: SQE error found at end of packet transmission.
[9] PAU
The Transmission Paused high indicates the next normal packet
transmission process will be paused temporally because EMC received a
PAUSE control frame, or S/W set bit SDPZ of MCMDR and make EMC to
transmit a PAUSE control frame out.
1’b0: Next normal packet transmission process will go on.
1’b1: Next normal packet transmission process will be paused.
[8] DEF
The Deferred Transmission high indicates the packet transmission has
deferred once. The DEF is only available while EMC is operating on half-
duplex mode.
1’b0: Packet transmission doesn’t defer.
1’b1: Packet transmission has deferred once.
[7:4] CCNT
The Collision Count indicates the how many collision occurred consecutively
during a packet transmission. If the packet incurred 16 consecutive collisions
during transmission, the CCNT will be 4’h0 and bit TXABT will be set to 1.
[3] Reserved -
[2] RFFull
The RxFIFO Full indicates the RxFIFO is full due to four 64-byte packets are
kept in RxFIFO and the following incoming packet will be dropped.
1’b0: The RxFIFO is not full.
1’b1: The RxFIFO is full and the following incoming packet will be dropped.
[1] RXHA
The Receive Halted high indicates the next normal packet reception process
will be halted because the bit RXON of MCMDR is disabled be S/W.
1’b0: Next normal packet reception process will go on.
1’b1: Next normal packet reception process will be halted.
[0] CFR
The Control Frame Received high indicates EMC receives a flow control
frame. The CFR only available while EMC is operating on full duplex mode.
1’b0: The EMC doesn’t receive the flow control frame.
1’b1: The EMC receives a flow control frame.