Rainbow Electronics W90P710CDG User Manual
Page 487
W90P710CD/W90P710CDG
- 488 -
31
30
29
28
27
26
25
24
Reserved
23
22
21
20
19
18
17
16
Reserved
15
14
13
12
11
10
9
8
Reserved
7
6
5
4
3
2
1
0
Reserved
ASS
SS_LVL
SSR[1:0]
BITS
DESCRIPTIONS
[3]
ASS
Automatic Slave Select
0 = If this bit is cleared, slave select signals are asserted and de-
asserted by setting and clearing related bits in SSR register.
1 = If this bit is set, usi_ss_o signals are generated automatically. It
means that device/slave select signal, which is set in SSR register is
asserted by the USI controller when transmit/receive is started by
setting CNTRL[GO_BUSY], and is de-asserted after every
transmit/receive is finished.
[2]
SS_LVL
Slave Select Active Level
It defines the active level of device/slave select signal (usi_ss_o).
0 = The usi_ss_o slave select signal is active Low.
1 = The usi_ss_o slave select signal is active High.
[1:0]
SSR
Slave Select Register
If SSR[ASS] bit is cleared, writing 1 to any bit location of this field sets
the proper sui_ss_o line to an active state and writing 0 sets the line
back to inactive state.
If SSR[ASS] bit is set, writing 1 to any bit location of this field will select
appropriate sui_ss_o line to be automatically driven to active state for
the duration of the transmit/receive, and will be driven to inactive state
for the rest of the time. (The active level of usi_ss_o is specified in
SSR[SS_LVL]).
NOTE: This interface can only drive one device/slave at a given time.
Therefore, the slave select of the selected device must be set to its
active level before starting any read or write transfer.